Features
- Whole house continuous hot water system
- Up to 8.5 GPM of endless hot water - never run out
of hot water
- Thermal efficiencies up to 88%; Energy Factors (EF)
up to 0.87
- Remote water temperature control
- Space saving, compact size
- Output temperature can be adjusted to provide specific
water temperatures for home, schools, nursing homes,
etc.
- Maintenance/diagnostic codes are displayed on the
remote controls simplifying service calls
- Direct electronic ignition (no standing pilot)
- Very low noise level
- Safe, low voltage remote controls
- All parts are replaceable
- Life Expectancy of 20+ years
- Residential warranty: ten years heat exchanger,
five years all other parts
- Commercial/space heating warranty: five years all
parts
Safety Devices
- Flame rod indicates flame failure
- Over heat sensor activates at 194° F
- Boiling protection switch activates at 203° F
- Thermal fuses activate at 264° F
- Built-in freeze protection to -30° F
- Combustion fan rpm check indicates blocked flue
or intake vents
- Power supply is protected by two 3 amp glass fuses
- Surge protector in line with power supply
Residential Remote Control
Residential Remote Controls
- Model MC-45 controller
- Model BC-45 and BSC-45 controllers
- All remote control units display diagnostic codes
if the water heater needs maintenance or service
- Can use a maximum of 3 remotes with any installation
- You can not use two of the same model remotes on
the same system. If this is done, one remote will
cancel out the other
- All Rinnai remotes provide an anti-scald safety
feature. Once water is flowing, and the water heater
is in operation, they will not allow you to adjust
the water temperature above 110°F
- Remote controls can be used for troubleshooting
& diagnostics
- To display the Maintenance codes (9 are stored)
- Press priority button "P", followed by the thermostat
button "H". (Repeat this procedure to stop the
maintenance code display loop.)
- To display Water Flow through water heater -
Press thermostat button "H", followed by the priority
button "P".
- To display Outlet Water Temperature - Press
thermostat button "C", followed by the priority
button "P"
Pipe Cover - Internal or External Units
Recess Box - Outdoor Units Only
|
or
